Blog Moved
Friday, April 3, 2009
I want to apologize to everyone that has been following this blog. It was just brought to my attention that the link to the new blog was not here. So, now you can continue following the build and
Bunks
Friday, October 10, 2008
As usual, I took the measurements and cut the parts with the CNC. I cut the forward bunk and the aft self-draining deck with access hatches. I am 6’3” and I fit the forward bunk just fine. With a 4”-
Bunk Supports
Monday, October 6, 2008
Measured and cut the bunk supports. I had to break out the chisel to cut the notches in the longitudinals for the cross braces. I was not looking forward to it, but it turned out to be easier than I
Bulkhead 8
Wednesday, October 1, 2008
Again, I used the computer and CNC to input the dimensions and cut the part. However, this part took some considerable trimming on the bottom to get it to fit in the right place within the hull.
Floors and Hull Braces
Friday, September 19, 2008
Cut and install the floors and support braces. Also key sanded and completed some more of the lower fillets below the bunks. I took the measurements along the keel line and entered them into the
Currently constructing 2 Wharram TIKI 38’s. You can keep track of us here.